Enphase M190, M210 Cable & Solar Junction Box, Seal, 1" conduit nipple/coupling

Description

Coleman Air
Enphase M190, M210 Cable & Solar Junction Box, Seal, 1" conduit nipple/coupling
Specially designed for DIY solar
panel installations.
This junction box is designed to sit on the roof itself, often under a solar panel.
It is ready to go, with 1" conduit nipple and compling included.
The wiring from the solar panels enters the bottom of the junction box and is routed through to the back of the box,
through the roof, and on to the inverter, disconnect or sub-panel. You can of course use the box for multiple strings.
The back of the junction box has a 1" soft rubber pad that provides a perfect seal on most all roofs.
Please see the picture of the box as it is installed.
PRODUCT OVERVIEW
For use in Enphase solar installation,with M190 or M210 Micro-Inverters.
Pre-drilled holes on the back of the junction box and rubber pad.
Rubber pad is soft and compressible, forming to minor to moderate roof and shingle irregularities.
Self sealing, soft rubber pads, minimize or elevate the use of any type of sealant.
Extremely weather resistant.
Unique design -- Super quick installations, just drill out a hole in the roof for the coupling and screw the junction box down.
Can be used on wood, shingle and composite roofs as well.
Also Included -- Enphase Energy AC Interconnect Cable 6 Feet. Part number ECWP-6
This cable is the same cable found in the Enphase part number EKIT-01-001 Install Kit.
New, never used. Cable for the Enphase system Inverters. This is the twist lock connector type, not the lines that go to the solar panel.
6ft cable for Enphase M190 or M210 Microinverter systems that connects the trunk lines to the AC junction box.
This item packaging has the part number as 860-00006 REV 03, The actual wire has the part number 840-00021 REV 03 1110. The Enphase part number is ECWP-6
It is possible that these were externally sourced by Enphase.
Please be certain this is the correct cable you need.
* Note: These are brand new unused cables. I am selling these at a great discount.
This item consists of
1) 6X6X4 Wiegmann NEMA 3R outdoor enclosure (junction box), with lockable lid. - UL Listed
1) Rubber, self sealing pad (This pad compresses and seals against moisture when screwed down to the roof)
2) 1" Galvanized lock nuts
1) 1" x 2" Galvanized Conduit Nipple
1) 1" Galvanized Conduit Coupling
1) Enphase M190/M210 Cable - Part number ECWP-6
Please note. Any Unistrut channel, inverters, tools and/or solar panels shown in the photo(s) are not included, only the exact items specified above.
Precision cut on our Waterjet cutter in Coleman Texas, U.S.A
Perfect for DIY Solar racking!!
If you have any questions, please do not hesitate to ask, we are happy to help
.
Thanks For Looking!
Coleman Air -- Empowering Innovation
GetAway Power
Wind and Solar Controllers, Electronics, Hardware & Accessories perfect for the DIY'er.
Empowering Innovation
Powered by SixBit's eCommerce Solution